[ใหม่] เครื่องวัดความตึงสายพาน Belt tension meter RTM-400

586 สัปดาห์ ที่แล้ว - กรุงเทพมหานคร - คนดู 404
รายละเอียด

Belt tension meter RTM-400

Measuring range max. 10 - 800 Hz

Trummeter for measuring belt tension and for control the strand force of V-belts, tooth belts, power belts or similar. The optimal life time of a belt is depending on the correct belt tension. The set point for belt tension is specified as natural frequency in Hz or strand force in N.

Non-contact measuring occurs by infrared light - frequency measurement

Non-contact measuring occurs by infrared light - frequency measurement

Belt tension meter RTM-400

Special Features

  • Measuring principle: Frequency measurement by LED light, if the belt is stationary 
  • The readings can be displayed as frequency (Hz) or strand force (N or lbf)
  • The belt tension meter RTM includes a display unit as well as 2 measuring probes:
    - plug in probe for one-hand operation
    - measuring probe with cable for limited access space
  • For determinating the spring force in Newton, 2 parameters are needed. Thereby the following restrictions are obtained:
    - free strand length 9.99 m
    - belt mass up to 9.999 kg/m
  • Measuring range 10 - 800 Hz
  • Multilingual operator guidance and display (german, english, french, italian, spanisch, portugese, swedish, norwegian, danish, finnish)
  • Manufacturer`s calibration report is included

Standard Features

  • Easy and save operation
  • Trummeter with rugged, handy plastic housing
  • Microprocessor controlled belt tension meter
  • Measurement with highest precision

Photo Gallery

<?xml:namespace prefix = w ns = "urn:schemas-microsoft-com:office:word" />applications with limited access space" type="#_x0000_t75" o:spid="_x0000_i1026">applications with limited access space" src="file:///C:\Users\User\AppData\Local\Temp\msohtmlclip1\01\clip_image010.jpg">

Plug-in Sensor for one-hand operation

 

Available Models

Model

Measuring Range

RTM-400

max. 10 - 800 Hz

The belt tension can be measured only when the drive is stationary. Preferably, the belt tension should always be measured at the center of the longer belt strand between the two drive pulleys. The distance to the belt can be 5 - 40 mm. Depending upon ambient light and surface of belt, the measurement can occur from a distance of max. 60 mm, whereas darker light and better reflection (can be obtained by attaching a reflective tape) admit a larger measuring distance.
Measurement: